![]() * 4 oz cold Coffee an irish coffee mug filled * 1/2 oz Galliano Pour all ingredients into bcm63xx_enetsw bcm63xx_enetsw.0: link DOWN on port1īusyBox v1.19.4 ( 18:24:56 CEST) built-in shell (ash)Įnter 'help' for a list of built-in commands. sd 2:0:0:0: Attached SCSI removable disk sda: p1 size 2049024 extends beyond EOD, truncated sda: p1 size 2049024 extends beyond EOD, enabling native capacity sd 2:0:0:0: Assuming drive cache: write through usb-storage 1-2:1.0: USB Mass Storage device detected usb 1-2: new high-speed USB device number 6 using ehci-platform Note that gpios need to be configured as inputs, to get the state when pressed/released a button. I'll integrate this stuff in a new build.įor buttons you need to monitor the value (1 or 0) when pressed and released a button, either using the mentioned script or else with gpioctl. ![]() ![]() Ok, good job, about WLAN probably the led is controled by the wifi chip itself not a GPIO. I don't know how to test the buttons (wifi, reset, wps). I followed theinstructions here for GPIO: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |